Lambda Standing Desk
Setup Instructions
Setup video below instructions.
Place the side pieces on the ground with the extendable leg sections facing up. There are cable tray insert slots on the back brace and these need to facing upwards. Insert the back brace hooks into the slots on the inside of each side piece and slide down to connect them
Pull out the extendable legs fully to ensure a locked position.
Place the desk frame upright then apply your body weight to the back brace to ensure the side pieces and back brace are in correctly. The tighter the back brace, the more stable the desk.
Assemble the cable tray by squeezing the two side pieces onto either side of the middle tray piece.
Slide the cable tray hooks down onto the assisted slots on the back brace.
While holding the desktop on a 45° angle, hook the back tab of the desktop into the highest knotch of both of the side pieces. Now move the desktop down to a 90° angle so it lays flat.
Ensuring the curved edge of the top shelf is facing you, align the 'T' on the underside of the top shelf with the holes on the top of each of the side pieces and press the top shelf down into place.
Your Lambda Standing Desk is now assembled. Lift the desktop and slide it up or down to change its height to fit your ergonomic profile.